Our plan kit shows how to build wood floating docks.

Outside Corner Female has 2 each 1/2" tabs with a hole for 3/4" bolt or pin. 8 1/2" L x 5" H use with HL-OCM or HL-SM

Outside Corner Male has 1 each 1/2" tab with a hole for 3/4" bolt or pin. 8 1/2" L x 5" H use with HL-OCF or HL-SF

Outside Corner End is used at end of fingers or docks. Good for swim floats. 8 1/2" L x 5" H.

Inside is used with an outside corner to sandwich the wood - corner gussett adds strength to dock. 8 1/2" L x 5" H.

Angles are used with cross stringers - use with 2 each HL-W 2 1/2" L x 5" H.

Washer Plates are used with angles - 2 with each angle. 1 1/2" L x 5" H.

Single "T" Female has 2 each 1/2" tabs with a hole for 3/4" bolt or pin. Bolts to side of dock to attach fingers. Use also for ramps. 5" L x 5" H.

Single "T" Male has 1 each 1/2" tabs with a hole for 3/4" bolt or pin. Use with HL-OCF or HL-SF. 5" L x 5" H.

3" Pipe Holder bolts to the side of dock. Uses 2 HL-W as back up plates. Uses 2" pipe to hold dock in place.

Chain Retainer bolts to side of dock and uses chain to hold dock in place. Use chain up to 1/2". Use 2 HL-W as back up plates. 6" L x 5" H.

Cleat Angle has slots to accomodate various size cleats and keep cleats from pulling out. Use HL-W as backup plates. 5" L x 2 1/2" H.

Backup Plate is used for additional strength behind HL-SM and HL-SF. 5" L x 5" W.

Lag Bolt Set is 3/8" x 3" hot dipped galvanized bolt and washer. Used to attach float drums.

Carriage Bolt Set is 3/8" x 2 1/2" hot dipped galvanized bolt, washer and nut. Used to attach 1-10 components to wood.

Hex Bolt Set is 3/4" x 3 1/2" zinc plated bolt and nylon lock nut. Used to connect dock together.

Connector Pin Set is 3/4" zinc plated pin and hitch clip pin used to connect dock together.